What's up everyone. Im selling my Allenbuilt Shortblock that I ran this past season. It only has 8 races on it. Its a 90x99 with custom CP pistons and custom InlinePro rods with ACL race bearings. Im listing a breakdown of what it would cost to build this new so you can have an idea. This is not a list of parts that I am selling and I will not part out the shortblock.

Stock K24 shortblock-$400
Custom CP pistons-$800
Custom InlinePro rods-$800
AEBS sleeves by InlinePro-$1275
ACL race bearing set-$160
OEM k20 oil pump-$145
Labor shortblock assembly by Jeremy Allen-$1250

Total-$4830- **This is not my asking price**

Im looking to get $3700 obo for this shortblock. Its in great shape and the compression test in all four cylinders were damn near dead even. Only things that are missing is the timing chain and timing chain cover. Im not looking for any type of trades. Please bump if you read this. Now on with the pics.

One of our customers ordered a shortblock from us and changed his mind deciding to go with a supercharged motor instead so his loss is your gain.

This is an Iron block Romeo engine.
It has a stroker crank so the displacement is 5.0L
It has:
Probe forged pistons
Eagle forged H-Beam rods
remachined and balanced cast stroker crank
Total Seal rings
etc.
The engine is built for 10.5:1 compression and is ready to go.

It is profesionally machined and balanced and good to go and comes with a limited workmanship warranty.

Normally we sell this engine for 3300.00 but your price is 2500.00

I will even give someone a break on install if they choose to have it installed with us.